02-16-2009, 03:52 PM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
Join Date: Jan 2009
Location: Mt. Sterling, KY
Posts: 131
|
|
First time load for the HX40
Yesterday I hauled 2 loads of 18 1500lbs. hay rolls from Mt. Sterling, KY to Grayson, KY. Not a huge trip, just 150 miles both ways. Had to stop and fill up at a truck stop and decided to run through the scales to see how much I weighed. GVW was 40,500lbs. After that I hit the interstate, set the cruise on 70, and sat back. There are some pretty good hills on I 64 once you get East of Morehead. The truck only went down to 65 and the pyro never got higher than 1300 degrees. Boost pressure stayed at 37psi. I could not have been happier. I was a little worried about having oversize injectors and towing with them, but everything stayed where it should have. Now, I did put the Smarty on CAtcher # 1 and the TST was purely for timing advance only with it on 1/0. Not bad for a 3/4 ton.
__________________
2005 Dodge 2500 4dr 4x4 G56, Schied injectors, HX40W Turbo, Haisley Machine dual disk clutch, Smarty revolution, TST Power Max CR, Fass 150, AFE Stage 2 intake, Magnaflow muffler to a 5in. Grand Rock Stack, Full gauge set, Firestone ride right airbags and compressor, B and W Gooseneck hitch
|
|
|
|