The truck was running fine even after a few trips in to town. On the last trip I parked it went in to the hardware store. After about 10 min. I stared it up again. It was running rough and rpm’s were going up and down about 200 rpm’s. I have very little throttle response.
I disconnected the EZ and that made no difference.
The codes I got are as following
P0236 (M) Map Sensor Too High Too Long Problem detected in turbocharger wastegate
P0743 (M) Torque Converter Clutch Solenoid/
Trans Relay Circuits
An open or shorted condition detected in the torque
converter part throttle unlock solenoid control circuit (3 or
4-speed auto. trans. only).
P0236 (M) Map Sensor Too High Too Long Problem detected in turbocharger wastegate.
P0753 (M) Trans 3-4 Shift Sol/Trans Relay
Circuits
An open or shorted condition detected in the transmission
2-4 shift solenoid circuit (4-speed auto. trans. only).
P1693 (M) DTC Detected in Companion Module A fault has been generated in the companion engine
control module.
Not sure which one applies
P1693 (M) DTC Detected in PCM/ECM or DTC
Detected in ECM
A 9Companion DTC9 was set in both the ECM and PCM.
P1765 (M) Trans 12 Volt Supply Relay Ctrl
Circuit
Current state of solenoid output port is different than
expected (4-speed auto. trans. only).
Any help would be appreciated
Thanks
Tom
02, 2500 QC 4X4 AUTO, LB, SLT, AFE, Edge EZ, Dodgezilla, DDII, DTT 89% TC,
VB, Trans. up grade kit, Smart Controller, Pac Brake, Mag-Hytec DD.
Linear Mode
