09-25-2005, 07:15 PM
|
#1 (permalink)
|
Offline
|
|
Join Date: Jul 2000
Location: Barrington, NH, USA
Posts: 1,139
|
|
No trailer connection indicated on Prodigy controller
Help,
Anyone know how to properly test a brake controller. I can not make a brake connection with either of my trailers (dump and flatbed).
I just replaced my old Commander XP with a new Prodigy this morning hoping this would fix my problem, but it has not.
Prodigy is connected properly and works as indicated in the instructions: (n.c., b.1., b.2., b.3. codes as well as the manual switch).
With a test light I have verified the 7-pin connector at the back of the truck for: left and right turn signal, running lights, brake lights, and the power pin to the ground pin ... all work fine).
But when I connect either of the trailer plugs to the truck I get no connection indicated!!! All I get is (. . ).
Am I doing something wrong? Is there a test I'm not doing or not doing right?
Without these trailers I am SOL on my side jobs and wood season is starting and I need to get my backhoe to specific sites for work.
Can anyone direct me as to what to look for ... both trailers worked fine only a week ago.
__________________
2008 ST Reg Cab 4500 4X4 G56 168.5".
2004 Kubota BX23 TLB.
2003 VW GLS Jetta TDI 5-speed.
1997 2500 ST 4x4, 4.10 axle, NV4500HD, 13.25 Luk HD clutch, #10 plate & AFC Spring kit, 370 Inj, PDR HX40 Turbo, 3K GSK, limited slip axle, AFE, 4" exhaust, Luke's Link, KDP fixed. ATS manifold.
|
|
|
|