12-02-2006, 11:01 PM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
Join Date: Jun 2004
Location: Morganton, NC
Posts: 53
|
|
HELP!!! New headgasket and fuel plate change and no power.
I just changed the headgasket on a 98 12V. Everything was straight forward. The only thing I had a question about was the crank pulley. It did not have a key way in it, so I assume it could be installed any way. Well after I changed the head gasket, I slid his torque plate back towards the firewall as to remove some of the power. It was boosting 35# before and he wanted a safe 25#. Well got it all put back together and truck runs fine except when you drive it, it will not make over 5# of boost. No smoke and no power. Also anything after about 1/3 throttle there is nothing. If 5th gear if you ride down the road and mash the throttle to the floor, nothing happens. Any ideas what I have done wrong.
Thanks in advance.
__________________
Allen Rolland
Graduate Mechanical Engineer
Clemson University
1998 2500 12 Valve
315x75-16 BFG, CenterLine Polished Rims, BD Brake, SouthBend Clutch, 100% Amsoil, Line-X Lined Bed and Roll Pans, BHAF, Torque Tube, Custom Plate, Ramsey REP 8000 Winch/ Hidden Mount
|
|
|
|