05-13-2007, 08:21 AM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
|
|
Kilby Generator Pulley Replacement
OK. I set aside the weekend to put the Kilby air compressor kit on, and I got to this step:
Quote:
|
7. Replace the generator pulley with the combo pulley supplied in the kit.
|
Does anybody know how to do this? I've got an '06, and the Bosch generator pully appears to be held on by some sort of weird spline nut. I took it to Pep Boys & Napa, and they were both clueless. The dealership is closed, but the service manual says that any problem whatsoever with the generator is to be resolved by R&R'ing the entire unit, so I don't think they are going to be helpful on this issue. (Actually, I don't think dealerships are set up to be helpful on any issue).
The truck is down until I can find a way to replace this pulley and put the generator back on the truck.
__________________
2006 2500 2WD Laramie Megacab CTD - HT 62/13 SS turbo,Scheid cam&port&springs&studs,ZZ manifold,Hot Juice&EZ,aFe Stage 1,DPP Cool Hose&TAG&EAG,Spearco IC,ATS ex. man.,Flux 1's,DIY CP3 mods,T&C Rail,GDP Fuel+2µ filter+intake,Rokktech Muffler,HTS billet trans,CalTracs,OBA,CoolingMist--- My Gallery
|
|
|
|