07-18-2008, 01:03 AM
|
#1 (permalink)
|
Offline
|
|
|
|
"0" Oil Pressure
On the way home driving along all is well. Cruising abt 45 or so, ding, ding, check gages light on. Oil gage reads 0 psi. Turned A/C & radio off, put windows down - sounds normal? Pop in neutral, sounds fine at idle, rev engine all sounds fine. I figure it's the oil pressure sensor (sender unit) and drive home. Pull the sender unit out (32 mm deep socket) and ohm it out - 3 pins - left - middle - right. Get nothing from middle pin to L or R, L to R reads 1250 ohms.
What do you all think?
I just checked AutoZone.com | System Error
$189.99  I was expecting $30 or 40.
Thanks,
__________________
99 2500 4X4 QC LB SLT Laramie Lt. Driftwood DTT QD 64/14 Mach 5s Comp ATS-3pc 4" Magnaflow 3:54s-locker in rear 285X75X16 Michelin Bilsteins bst/egt trans & fuel on "A" pillar Westin S/S steps. Truck Caught Smoking Spring Fling 07  522.69/998.83
1st SO-VP replaced 3/09
Last edited by Joe Mc; 07-18-2008 at 01:10 AM..
|
|
|
|