08-07-2008, 03:46 AM
|
#1 (permalink)
|
Offline
|
|
|
|
Need help with VP44 install
I need some help guys. I installed a VP44 today and while I was removing the rear most clamp down bracket for the High Pressure lines for cylinder 5 and 6 I dropped the clamp pieces. Now I'm not sure if I have all the parts.
This is the rear most clamp that attaches to a bracket for lines five and six. I have the two blue plastic pieces that go under/over the lines and I have the metal clip that goes on top of the upper blue plastic piece. What I'm not sure of is if there is a metal clip that goes under the lower blue plastic piece, or does the blue plastic piece just sit against the bracket.
If someone could take a look at their engine, or even take a picture and post it, I would greatly appreciate it.
Thanks
__________________
01.5, 2500, QC, 4x4, Auto
Isspro EV (Pyro, Trans, Boost)
Dakota FP Guage
Stull Running Boards
Mag Hytec 727DD Pan, Rear Cover,
DSS,
Firestone Bags,
PullRite Hitch,
Carter Pusher
2WL
MBRP 4"
Frantz
Bilstein 5100's
ProWeld Trans Cooler
Edge J/A, J-Hook
Tom Tom GPS
83,000 miles
|
|
|
|