03-13-2003, 07:39 PM
|
#1 (permalink)
|
|
Non Member
Offline
|
|
Join Date: Oct 2002
Location: Tallahassee FL
Posts: 162
|
|
Ball joint removal?
I am replacing my upper and lower ball joints on my 95 Ram 2500 2wd. Are there any special tips or tools that would be helpful? I got a ball joint seperator at autozone to remove the spindle. Unfortunately I ripped apart the rubber boots on the ball joints in the process. This whole mess started with new brakes. Found out that one of the bolt hole for the caliper was stripped out. (not by me) So I tried to install a helicoil. Broke the treading tool off in the spindle. Removed the spindle only to rip the rubber boots on the ball joints. This sucks. I'm doing this work in my driveway at night after work. An hour here and an hour there. I'm about to pour gas on it and light a match.
Thanks in advance for your help,
Jeff
__________________
95 2500 4x2 Auto Reg cab long bed :B1-2 ex4, 370s, TST #4, 4000 GSK, AFC kit, Suncoast tranny, HD springs, AFE, 5" BD exhaust, lazer cut DVs.
98 2500 4x4 Auto QC long bed:II SPS 62/14, II 370s phase 3, #8 plate, 4000 gsk, Suncoast billet tranny, HD springs, AFE 2, Rip 4" exhaust.
04.5 3500 4x4, QC, lwb, auto,srw
|
|
|
|